Table of Contents Important Safeguards Introduction Installation Operation Cleaning Pattern Automatic Shutoff and Removal Maintenance Warranty 2 3 4 5 5 6 6 8
! WARNING: To reduce the risk of fire, electrical shock, injury, or damage to your product or to bathers: ! Do not use if unit is damaged in any way. ! Use this product only for its intended use as described in this manual. ! Unit must be submerged in water to operate properly. ! When not in use, store indoors in a clean, dry place. Do not leave underwater, in direct sunlight, or exposed to extreme temperatures.
Congratulations on your purchase! You will find RoboKleen to be the most effective pool cleaner available. Unlike water-powered cleaners, which put all dirt and debris through your existing pool pump and filter, Robo-Kleen has its own pump and filter system. This saves you money in electricity costs and extends the life of your existing pool equipment. Read carefully before using your Robo-Kleen pool cleaner.
Underside of Mobile Cleaning Unit Locking Tabs Suction Ports Cleaning Brushes Locking Tabs Installation The power supply should be positioned so that Robo-Kleen can reach all the walls of the swimming pool and must be at a minimum distance of 10 feet from the edge of the pool. CAUTION: INSURE THE THE 110V MAIN LINE OUTLET IS PROTECTED BY A GROUND FAULT CIRCUIT INTERRUPTER (GFCI) OR EARTH LEAKAGE CIRCUIT INTERRUPTER (ELCI). OTHERWISE, DEATH OR INJURY CAN RESULT.
Operation ! DO NOT ENTER THE SWIMMING POOL WHILE ROBO-KLEEN IS IN OPERATION TO AVOID ENTANGLEMENT WITH CORD a. Connect the cable to the power supply b. Grasp the cleaner by a side handle and place Robo-Kleen in the pool. c. Rock the unit from front to back and side to side, releasing trapped air, until the unit slowly sinks to the bottom of the pool. d. Start the unit at a 90˚ angle to a wall .
Automatic Shutdown and Removal Robo-Kleen will automatically shut down after a work cycle of approximately 3 hours. Switch off the power supply for at least 30 seconds before restarting. ALWAYS SWITCH OFF THE POWER SUPPLY BEFORE REMOVING ROBO-KLEEN FROM THE POOL. Remove Robo-Kleen from the water by GENTLY AND SLOWLY pulling in the cable. WHEN ROBO-KLEEN REACHES THE SURFACE, LIFT IT OUT BY THE HANDLE - NOT BY THE CABLE.
b. Pull one of the 4 red tabs out and remove the filter bag from the bottom lid. Turn the filter bag inside out. Use a garden hose to wash it thoroughly. The bag should be laundered periodically, using a regular wash cycle. c. Rinse the bottom lid parts and bottom brushes. d. Refit the filter bag with the fluffy surface inward. Start from one corner - align one of the red tabs with the corner.
TWELVE MONTH LIMITED WARRANTY Twelve month limited warranty in Continental USA only from date of original purchase for manufacturing defects under normal and reasonable use, and subject to the maintenance requirements and installation guidelines set forth in the product instruction manual.