Manualshelf

Integration Guide

ManualsBrandsSmartrek Technologies ManualsElectronics900 MHz Mesh Network Long Range Transceiver Module
12345678910
SMK900 Integration Guide Revision 4
Trigger
Description
Bootup
Bootup system initialization
Enter Seek Mode
The transceiver is attempting communication with the gateway over the mesh
network.
Leave Seek Mode
The transceiver has established a link to the mesh network.
Enter Broadcast
The transceiver wakes up to enter the broadcasting cycle
Leave Broadcast
Broadcasting cycle has ended and the transceiver is ready to enter sleep mode.
Serial Event
A message from a local serial device has been received by the transceiver. Note:
The local serial device must read CTS low before sending.
Air command
An execute air command message has been received. Typically, air command is
used to control or read modules connected to the radio.
The available triggers in the mesh network cycle are shown in the figures below.
Mesh network triggers
External triggers
10