Smartrek Technologies 900 MHz Mesh Network Long Range Transceiver Module : Integration Guide : Page 39

SMK900 Integration Guide Revision 4

SMK900 Certifications Information

Smartrek Technologie module

FCC ID: 2AP8V-SMK900

IC: 24079-SMK900

United State (FCC)

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Antenna Gain Restriction and MPE Statement:

The SMK900 radio has been designed to operate with any dipole antenna of up to 3 dBi of gain. The

antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from

all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

IMPORTANT: The SMK900 Module has been certified by the FCC for use with other products without any

further certification (as per FCC section 2.1091). Modifications not expressly approved by Smartrek

Technologies could void the user's authority to operate the equipment.

IMPORTANT: OEMs must test final product to comply with unintentional radiators (FCC section 15.107

and 15.109) before declaring compliance of their final product to Part 15 of the FCC rules.

IMPORTANT: The RF module has been certified for remote and base radio applications. If the module will

be used for portable applications, please take note of the following instructions the device must undergo

SAR testing.

OEM labeling requirements: As an Original Equipment Manufacturer (OEM) you must ensure that FCC

labeling requirements are met. You must include a clearly visible label on the outside of the final product

enclosure that displays the following content:

Contains FCC ID: 2AP8V-SMK900

The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (i. ) this device may not cause harmful interference and (ii. ) this

device must accept any interference received, including interference that may cause undesired

operation.

39