User's Manual

Manual Ver1.0
- 43 -
6.3 MAC Filter
Wireless MAC filter allows you to implement access control based on device’s MAC
address.
When you select “Allow” in “MAC Restrict Mode”, only data from devices with
matching MAC addresses in filter table can access AG10W. If you select “Deny” in
“MAC Restrict Mode”, every device can access AG10W except those which have
matching MAC addresses in the filter table. To add filter entry, click on “Add” and
enter the MAC address of AG10W. Click “Save/Apply” to save the configuration. To
“delete” the entry, select the entry and click “Remove”.
Figure 54. Wireless Setup – MAC Filter
6.4 Wireless Bridge
Wireless Bridge (also known as Wireless Distribution System) can bridge data
between two APs, which is particularly useful while wired cabling is not available.
Note: only APs in same channel can be bridged.
AP Mode: Wireless Bridge- listens and answers other APs only
Access Point- Wireless Bridge also with AP functionality
Bridge Restrict: Disabled- any AP will be granted access
Enabled- only selected APs (Max. 4) with specified MAC address
will be granted access
Enabled (Scan)- as above, but AG10W will scan available AP for
you to select.
Refresh: re-scan the available AP
Save/Apply: save the configuration