User's Manual

Manual Ver1.0
- 5 -
2. Installation
In addition to this document, your AG10W should arrive with the following:
• One standalone desktop AG10W
• One power adapter and power cord
• One Ethernet cable with RJ-45 connector
• One telephone cable with RJ-11 connector
Front Panel
The front panel LEDs indicate the status of the unit.
Label Color Function
PWR Green On: Power on
Off: Power off
LAN1~4 Green On: LAN link established and active
Off: No LAN link
Flashes during data transfer
DSL Green Flashes during the training mode.
On: ADSL link established and active
Tx/Rx Green On: Router is active
Flashes during data transfer through ADSL line
WLAN Green On: WLAN enabled
Off: WLAN disabled
Flashes during data transfer
Rear Panel
The connectors located at the rear panel have the following functions.
Interface Function
Botton Power switch on/off
Power (SNG 1- tec) Connects to the power adapter cable
Reset Resets unit’s configuration to factory default
LAN1~4 RJ-45 connector: Connects AG10W to your PC's
Ethernet port, or to the uplink port on your LAN's hub
ADSL RJ-11 connector: Connects AG10W to ADSL line