User's Manual

DSL Gateway/Router — User Manual
Page 19 Total 20 Pages
subsequently popped up is the command line window.
Note 3：The returned values of ping command in the following format show the standard of “reachable”
Figure 5.1
6
、
If ping of the modem is reachable but ping of the outer fixed IP is unreachable, attention should be
concentrated upon device settings. Please enter the configuring interface following the instructions in
this manual.
（1） Check first the number of connections. If more than one connection exists, for troubleshooting ,
delete unused connections and remain the one connection you are using.
（
2
）
Check the connection to see whether correct “type” is selected. It’s normal to choose login type of
PPPoE. When you use PPPoE to login, the following information should be provided: VPI and
VCI, which can be queried from your ISP, user name and password.
（3） Then make sure that “using NAT ” and “default gateway” have been selected with a tick. Check
whether “connect on demand” has been selected with a tick. If it is selected, the connection is
activated only when traffic to outer networks arrives. If not selected, check “keep connection”,
which should be set to 0 if you demand to keep connection
Make sure that the above parameters are saved after configuration. Internet is now available since the
configuration is properly done.
About FCC certification:
This device complies with Part15 and Part68 of the FCC Rules.Operation is subject to the following
conditions:（1）this device may not cause harmful interference,and (2) this device must accept any
interference received,including interference that may cause undesired operation
ANNEX：SHIPPING LIST
ADSL MODEM
×1
Splitter ×
1
User Manual
×1
Power Supply
×1
Cable Cat5 RJ45
×1
Telephone Line
×2
Warranty Certificate ×
1