User's Manual

ADSL MODEM USER MANUAL
- 20 -
addresses through the LAN page.
2. Configuration of administrator’s password and user’s password
When logging on the setting page of ADSL Modem, the system requires user name and password to verify
for permission. The default administrator’s account is “admin” and the default password for this account is
“1234”. The user, through the user configuration tab on Administration page, can change the passwords.
(Attention: please remember the password after changing otherwise you will not be able to change
configuration after saving.)
5.3 WIRELESS CONFIGURATION
Press “WIRELESS” on the top of web pages to enter wireless section. You can select to configure
wireless setup, security and management.
5.3.1 WIRELESS SETUP
Click “WIRELESS” on the top menu to setup basic wireless parameters. In default, check “Access Point”
box to launch wireless AP.
5.3.1.1.Access Point Settings
 SSID (Service Set Identifier): The mobile users cannot access WLAN until setting their SSID as the same
value of the wireless ADSL. The SSID value of the ADSL is “default”
 Current Channel：To denote the different frequency of wireless signals whose value is from 1 to 11. The
default value is”11”. If there are more than one APs located in the same area, each of them must works at
different channels to reduce interference. For Example: Three APs are install in the same place, the AP’s
channel should be 1,6 and 11 respectively.
 Wireless mode: The default setting is 802.11b+g+n (Mixed mode). If you do not know or have among 11n
11g and 11b devices in your network, then keep the default setting
 Beacon interval: The Beacon Interval value indicates the frequency interval of the beacon. Enter a value
between 20 and 1000. A beacon is a packet broadcast by the Router to synchronize the wireless network.
 RTS/CTS Threshold: The RTS (Request To Send) threshold (number of bytes) for enabling RTS/CTS
handshake. Data with its frame size larger than this value will perform the RTS/CTS handshake. Setting this
attribute to be larger than the maximum MSDU (MAC service data unit) size turns off the RTS/CTS
handshake. Setting this attribute to zero turns on the RTS/CTS handshake Enter a value between 1500 and
2347.
 DMIT: This value, between 1 and 255, indicates the interval of the Delivery Traffic Indication Message
(DTIM).