User's Manual

ADSL MODEM USER MANUAL
- 5 -
Interface introduction:
a) Power Interface: 12V DC, 500mA. .
b) Switch: To turn on or turn off the power.
c) WIFI: To switch on or switch off the WIFI.
d) LAN1~LAN4: Connect Ethernet port of the Gateway with 10/100BASE-T port of the computer using the
network cable that comes with the modem
e) Line: Connected with phone line or “ADSL” port of the splitter.
1.3 LED STATUS INDICATION
Table 1.1
Steady light
Flashing
Fast flashing
Off
POWER (green)
Power on
/
/
Power off
DSL(green)
The modem is in
good connection
The modem is boot
OK
In handshaking status
Power off
Internet(green)
Route mode and
obtained IP address
Route mode and
Data transmitting or
receiving
/
Bridge mode or no Data
transmitting or receiving
LAN(1-4)
(green)
Ethernet line is
connected to PC
Ethernet is transmitting
data
Ethernet line not connected
properly
WLAN(green)
/
/
Wireless is transmitting
data
Disable Wireless
WPS(green)
/
/
Start WPS
Disable WPS
1.4 PROTOCOLS
ADSL Modem supports the following protocols:
1. PPPoA（PPP over ATM ） LLC encapsulation or VCMUX encapsulation (RFC2364)
2. PPPoE (PPP over Ethernet) LLC encapsulation or VCMUX encapsulation (RFC2516)
3. 1483 bridge（1483 Bridged IP over ATM）LLC encapsulation or VCMUX encapsulation (RFC1483)
4. 1483 routing（1483 Routing IP over ATM）LLC encapsulation or VCMUX encapsulation (RFC1483)
5. Classical IP over ATM (RFC1577)
1.5 FEATURES
1. Supports ANSI T1.413 ISSUE 2, ITU G.992.1 (G.DMT), ITU G.992.2 (G. LITE), ITU G.992.3 (ADSL2), ITU
G.992.5 (ADSL2+), Annex M.
2. Web-based configuration and monitoring.
3. Supports up to 8 PVCs.
4. Routing function.
5. NAPT、DHCP function.