User's Manual

DSL Gateway/Router — User Manual
Page 5 Total 7 Pages
2.2 HARDWARE CONNECTION
Introduction：
1、 Use a telephone cord to connect the LINE port of the splitter with the RJ-11 port (the phone jack) on
the wall.
2、 Use another telephone cord to connect the ADSL port of the splitter with the LINE port of the ADSL
Modem.
3、 Use another telephone cord to connect the telephone set with the PHONE port of the splitter.
4、 Connect Ethernet port of the ADSL MODEM with 10/100BASE-T port of the computer using the
network cable that comes with the modem.
5、 Plug in the power cord, and turn on the power.
If you do not want Internet services and telephone voice services simultaneously, please just connect the
LINE port of the ADSL Modem with the RJ-11 port (the phone jack) on the wall using a telephone cord. In this
case, the splitter is not necessary.
2.3 LED STATUS INDICATION
Table 2.3
Status
POWER
(red)
DSL (green)
INTERNET
(green)
LAN1-LAN4
WIRELESS(green)
Steady
light
Power on
The modem is in
good connection
/
Wireless is connected
Flashing
/
In handshaking
status
/
/
Fast
flashing
/
/
Transmitting or
receiving data
Transmitting
or receiving
data
Transforming data
Off
Power off
Connection not set
up
Not connected
with PC
properly
Not
connected
with PC
properly
Wireless is disabled