User's Manual

SMART/RG SR400ac 802.11ac Gigabit Router User Manual
37
The following table describes parameters in this page:
Field Description
PPPoE Username
Set the username to use when authenricating with a PPPoE
server.
PPPoE Password
Set the password to use when authenticating with a PPPoE
server
PPPoE Server
Name
Set the PPPoE server name.
PPPoE Access
Concentrator
Set the name of the PPPoE access concentrator.
PPPoE Connect on
Demand
Set whether the PPPoE link should be automatically
disconnected if no traffic has been observed for the period
specified by PPPoE Max Idle Time.
PPPoE Max Idle
Time
Set the number of seconds to wait before disconnecting the
PPPoE link if PPPoE Connect On is Enabled.
PPPoE Keep Alive
Set whether PPPoE link should be automatically restored if it
is lost. This setting has no effect if PPPoE Connect On
Demand is Enabled.
PPPoE MRU
Set the maximum number of bytes that the PPPoE interface
will receive in a single Ethernet frame.
PPPoE MTU
Set the maximum number of bytes that the PPPoE interface
will transmit in a single Ethernet frame.
After setting, click Apply to save the settings.
7.4 STATUS
Click STATUS in the navigation bar on the top pane of the page, the STATUS page
appears. You can check the system up time since the router was booted and the
log of recent connection attempts.