User's Manual

SMART/RG SR400ac 802.11ac Gigabit Router User Manual

The following table describes parameters in this page:

Wireless Interface Select which wireless interface to configure.

BSS-MAC (SSID) Select desired BSS to configure

Mode

Show whether the BSSID is AP, WirelessBridge, WET or

STA.

BSS Enabled Enable or disable this SSID.

Network Name (SSID)

Set the Network Name (also known as SSID) of this

network.

Network Type

Select Closed hides the network from active areas. Select

Open reveals the network to active scans.

AP Isolation

Select On enables AP isolation mode. When enables,

STAs associated to AP will not be able to communicate

with each other.

Network Bridge Select desired bridge br0 or br1.

BSS Max Associations

Limit

Set the maximum associations for this BSS.

WMM Advertise

When WMM is enabled for the radio, selecting On allows

WMM to be advertised in beacons and probes for this

BSS. Off disables advertisement of WMM in beacons and

probes.

WMF

Choose On to enable Wireless Multicast Forwarding on

this BSS. Off disables the feature.

DWDS Enable of disable Dynamic Wireless Bridge mode.

MCAST_REGEN

Choose On to enable Multicast Reverse Translation on

this sta. Off disables the feature.

Operational

capabilities mode

required

Set Operational capabilities mode required for stations to

associate to the BSS supported by the interface: none –

no requirements on joining devices. erp – devices must

advertise ERP (11g) capabilities to be allowed on a 2G

band BSS. ht – devices must advertise HT (11n)

capabilities to be allowed on the BSS. vht – devices must