User's Manual

ZXDSL 831AII User Manual
- 9 -
Figure 2.2
2.3.4 VDSL MODEM WORK MODE CONFIGURATION
1． For different protocols, the users need to set VDSL Modem accordingly as listed below:
Table 2.2
PPPoE
PPPoA
ATM VC Protocol Use DNS User Name Password
√ PPPoE Enable √ √
√ PPPoA Enable √ √
1483 Bridged
Lower interface Default route
√ Disable
Note: √ means configure according to VDSL service provider’s instructed value.
PPPoE can also be realized via third party dialup software.
User Manual
Reference Chapter
PPPoE PPPoA 1483 Bridged
3.3 3.3 3.2
2． After getting through every page for parameters set-up, click “Apply” to save the value in VDSL MODEM
3． Click the “Restore Default Settings” on “Management” Tab to enter the saving configuration page as
Figure 2.3. After the Modem reboot,The VDSL MODEM will work on the new parameters.