User Manual

INSTALLATION
1. Connect the DSL port of the gateway and the Modem port of the splitter with a telephone cable; connect the phone to the
phone port of the splitter through a cable; and connect the incoming phone line to the Line port of the splitter.
The splitter has three ports:
l Modem: Connect to the DSL interface of the gateway
l Phone: Connect to a telephone set
l Line: Connect to a wall phone jack (RJ11 jack)
2. Connect a LAN port of the gateway to the network card of the PC using an Ethernet cable.
3. Connect one end of the coaxial cable to the Coax port on the gateway and connect the other end of the cable to your setup
box.
4. Plug the power adapter into the wall outlet and connect the other end of it to the Power port of the gateway. Turn on the
unit by pressing the power button on the back of the gateway.
Note: If you use 3G WAN service, connect the 3G USB data card to the USB port of the gateway. If you use the Ethernet uplink,
connect the WAN port that is defined to the Internet with an Ethernet cable. The xDSL uplink, 3G WAN service, and Ethernet uplink
cannot coexist.
Your gateway is now automatically being set up to connect to the Internet. This process may take a few minutes to complete
before you can begin using your Internet applications (browser, email, etc.).
If you are unable to connect to the Internet, confirm that all connections are in place and the gateway’s power is turned on.