User Manual

User Manual
122
 The connection between the ADSL router and your computer, hub, or
switch.
 The running status of your PC, hub, or switch.
(3) Q: Why the DSL indicator is off?
A: Check the connection between the “DSL” port of router and the wall jack.
(4) Q: Why Internet access fails while the DSL indicator is on?
A: Check whether the VPI, VCI, user name, and password are correctly
entered.
(5) Q: Why I fail to access the web configuration page of the DSL router?
A: Choose Start > Run from the desktop, and ping 192.168.1.1 (IP address of
the DSL router). If the DSL router is not reachable, check the type of the
network cable, the connection between the DSL router and the PC, and
the TCP/IP configuration of the PC.
(6) Q: How to load the default settings after incorrect configuration?
A: To restore the factory default settings, turn on the device, and press the
reset button for about 1 second, and then release it. The default IP
address and the subnet mask of the DSL router are 192.168.1.1 and
255.255.255.0, respectively.
 User/password of super user: admin/admin
 User/password of common user: user/user
FC
C - PART 68
This equipment complies with Part 68 of the FCC rules and the requirements adopted
by the ACTA. On the bottom of the device of this equipment is a label that contains,
among other information, a product identifier in the format US:
VW7DL01BSR552N and REN: 01B for this equipment.
This equipment uses the following USOC jacks: RJ-11/RJ45/USB/Power Jacks！
A plug and jack used to connect this equipment to the premises wiring and telephone
network must comply with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone cord and modular plug is provided