User Manual

User Manual
9
Warning:
Do not press the Reset button unless you want to clear the current settings. The
Reset button is in a small circular hole on the rear panel. If you want to restore the
default settings, please press the Reset button gently for 1 second with a fine needle
inserted into the hole and then release the button. The system reboots and returns to
the factory defaults.
Avertissement:
N’appuyez pas sur le bouton RESET sauf si vous désirez effacer les paramètres de
configuration. Le bouton RESET est situé au fond d’un orifice circulaire situé sur le panneau
arrière de l’unité. Si vous souhaitez restaurer les paramètres par défaut, veuillez appuyer
doucement à l’aide d’une aiguille sur le bouton RESET pendant 1. L’unité redémarrera en
utilisant les paramètres de configuration par défaut.
3.2 Hardware Installation
3.2.1 Choosing the Best Location for Wireless Operation
Many environmental factors may affect the effective wireless function of the DSL
Router. If this is the first time that you set up a wireless network device, read the
following information:
The access point can be placed on a shelf or desktop, ideally you should be able to
see the LED indicators in the front, as you may need to view them for troubleshooting.
Designed to go up to 100 meters indoors and up to 300 meters outdoors, wireless
LAN lets you access your network from anywhere you want. However, the numbers of
walls, ceilings, or other objects that the wireless signals must pass through limit signal
range. Typical ranges vary depending on types of materials and background RF
noise in your home or business.
3.2.2 Connecting the Device
Step 1 Connect the DSL port of the router and the Modem port of the splitter
with a telephone cable; connect the phone to the phone port of the
splitter through a cable; and connect the incoming line to the Line port of
the splitter.
The spliiter has three ports:
 Line: Connect to a wall phone jack (RJ-11 jack)