User Manual

User Manual
31
does not stop, unless the modem is powered off and DSLAM or uplink
equipment is abnormal.
 PPP IP extension: If you want to configure DMZ Host, you should enable it
first.
 Use Static IPv4 Address: If this function is disabled, the modem obtains an
IP address assigned by an uplink equipment such as BAS, through PPPoE
dial-up. If this function is enabled, the modem uses this IP address as the
WAN IP address.
 Enable PPP Debug Mode:Enable or disable this function.
 Bridge PPPoE Frames Between WAN and Local Ports:Enable or disable
this function.
 Enable IGMP Multicast Proxy:If you want PPPoE mode to support IPTV,
enable it.
Step5 After setting the parameters, click Next to display the following page.
Step6 In this page, select a preferred WAN interface as the system default
gateway and then click Next to display the following page.