User Manual

User Manual
67
Click Add Firewall, and the following page appears.
 name: The name of firewall.
 interface: You can select LAN or WAN from the drop-down list.
 type: You can select IN or OUT from the drop-down list.
 defaultaction: You can select Permit or Drop from the drop-down list.
Click Add Rule, and the following page appears.
 enabled: Select the check box to enable the firewall rule.
 Protocol: You can select UDP, TCP, or ICMP from the drop-down list.
 Action: You can select Permit, Drop, or Reject from the drop-down list.
 RejectType: You can select the reject type, when you select Reject as the
action.
 IcmpType: You can select the type of ICMP packet, when you select ICMP
as the protocol.
 origIPAddress: The original IP address.
 origMask: The original subnet mask.
 origStartPort: The original start port.
 origEndPort: The original end port.