User's Manual

SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 107
Field Name Description
l Enable: The gateway automatically reverts to 20 MHz channel bandwidth
when another WiFi network within 2 channels of its own channel is detected or
when a client device with its 40 MHz Intolerant bit set is detected.
RX Power Chain Save Select whether to turn on power-save mode. Options are
Disable
and
Enable
. The
default is
Enable
.
Note: Before setting this parameter, set 802.11n/EWC to Auto.
RX Power Chain Save
Quiet Time
Enter the delay time (in seconds) between when system activity ceases and power-
save mode engages. Options are:
0
-
2147483647
seconds. The default is
10
seconds.
RX Power Chain Save
PPS
Enter a throughput threshold (in seconds) for when the router engages power-save
mode after the quiet time seconds have elapsed. Options are:
0
-
2147483647
pack-
ets per second. The default is
10
seconds.
54g™ rate This options is set to 6 Mbps and cannot be changed.
Multicast rate Select the desired packet transmit rate for multicast. Options are
Auto
and
6
-
54
Mbps
.
Basic Rate Select the basic rate. Options are
Default
,
All
,
6 & 12 Mbps
, and
6 &12 & 24 Mbps
.
Fragmentation
Threshold
Enter the size at which packets will be fragmented into smaller units. The primary
consideration for this setting is the size/capability of the circuit. Options are
256
-
2346
bytes. The default is
2346
bytes.
Note: A high packet error rate is an indication that a slightly increased fragmentation
threshold is needed. When possible, the default value of 2346 bytes should be main-
tained. Poor throughput is a likely result of setting this threshold too low.
RTS Threshold Enter the RTS (Request to Send) packet size beyond which the WLAN client hardware
invokes its RTS/CTS mechanism. Smaller packets will otherwise be sent not using
RTS/CTS. Options are
256
-
2347
bytes. The default is
2347
(disabled).
DTIM Interval Enter the Delivery Traffic Indication Message (DTIM or Beacon rate) countdown vari-
able used to indicate when the next window is available to client devices for listening
to buffered broadcast and multicast messages. Options are
1
and
65535
. The default
is
1
.
Beacon Interval Enter the time interval (in milliseconds) between beacon transmissions. Beacon trans-
missions make known the presence of an access point and convey to wireless NICs
when to awake from power save mode to check for buffered frames at the access
point. Options are
1
and
65535
ms. The default is
100
ms.
Global Max Clients Enter the maximum number of client devices that can connect to the router. Options
are
1
-
255
. The default is
80
.
Xpress™ Technology Select whether to enable Xpress Technology. This technology is compliant with draft
specifications of two planned wireless industry standards. Options are
Enabled
and
Disabled
. The default is
Enabled
.
Regulatory Mode Select whether to enable support for 802.11 regulations. Options are
Disabled
,
802.11h
, and
802.11d
. The default is
802.11h
.
Pre-Network Radar
Check
The radar check parameter setting for traffic trying to access your gateway from out-
side the network. The displayed value is
-1
.
In-Network Radar The radar check setting for traffic trying to access your gateway from inside your net-