User's Manual

SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 116
1. In the left navigation bar, click Diagnostics > Ethernet OAM. The following page appears.
2. Modify the fields as needed, using the information in the table below.
3. Click Apply/Save to commit your changes.
The fields on this page are explained in the following table.
Field Name Description
Ethernet Link OAM (802.3ah)
section
Ethernet Link OAM
(802.3ah)
Click the
Enabled
checkbox to set options for this protocol. The fields described
below appear. Only the
WAN Interface
and
Active Mode
fields are required.
WAN Interface Select the WAN interface that you want tested.
OAM ID Enter the ID of this OAM configuration. Only positive numbers are allowed.
Auto Event Select whether to create event log entries automatically.
Variable Retrieval Select to enable on-demand link diagnostics, including bit-error-rate approximation.
Link Events Select to enable reporting of critical conditions that may cause link failure.
Remote Loopback Select to enable on-demand link diagnostics, including bit-error-rate approximation.
Active Mode Click to enable this feature.
Ethernet Service OAM (802.1ag/Y.1731)
section
Ethernet Service OAM
(802.1ag/Y.1731)
Click the
Enabled
checkbox and then click
802.1ag
or
Y.1731
to set options for this
protocol. The fields described below appear. Only the
WAN Interface
and
Active
Mode
fields are required.
WAN Interface Select the WAN interface that you want tested.
MD Level (
Appears for the 802.1ag option only
) Select the domain level for this maintenance
domain. Options are
0
-
7
. The larger the domain, the higher the value you should
select.
MD Name (
Appears for the 802.1ag option only
) Enter the name of the maintenance domain,
e.g., Broadcom.
MA ID (
Appears for the 802.1ag option only
) Enter the MA ID, e.g., BRCM.
MEG Level (
Appears for the Y.1731 option only
) Enter the MEG level for this service.
MEG ID (
Appears for the Y.1731 option only
) Enter the MEG ID for this service.