User's Manual
Table Of Contents
- Welcome!
- Getting Familiar with your Gateway
- Installing your SR700ac Gateway
- Logging into your Gateway's UI
- Device Info
- Advanced Setup
- LTE WAN Service
- Wireless
- Diagnostics
- Management
- Logging Out
- Appendix: Compliance Statements
- Revision History
SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 30
Field Name Description
Enable PPP Debug Mode Select to have the system put more PPP connection information into
the system log of the device. This is for debugging errors and not for
normal usage.
Bridge PPPoE Frames
Between WAN and Local
Ports
Select to enable PPPoE passthrough to relay PPPoE connections from
behind the modem. Also known as Half-Bridged mode.
Enable Firewall
This option enables functions in the
Security
sub-menu and is
enabled by default. Click the checkbox to disable this option.
Network Address Translation Settings
section
Enable NAT This option is selected by default and enables sharing the WAN inter-
face across multiple devices on the LAN. Click the checkbox to dis-
able NAT.
Enable Fullcone NAT (
Available only when Enable NAT is selected
) Click to enable one-
to-one NAT.
Enable SIP ALG (
Available only when Enable NAT is selected
) Click to enable Ses-
sion Initiation Protocol (SIP) pass-through NAT. Used for Voice over IP
(VOIP) applications.
IGMP Multicast
section
Enable IGMP Multicast
Proxy
Click to enable Internet Group Membership Protocol (IGMP) mul-
ticast. Used by IPv4 hosts to report multicast group memberships to
any neighboring multicast routers.
Enable IGMP Multicast
Source
Select to enable this service to act as an IGMP multicast source.
MLD Multicast
section
Enable MLD Multicast Proxy Click to enable Multicast Listener Discovery (MLD) multicast. Used by
IPv4 hosts to report multicast group memberships to any neighboring
multicast routers.
Enable MLD Multicast
Source
Select to enable this service to act as an MLD multicast source.
MTU size Enter the MTU (Maximum Transmission Unit) size for SmartRG gate-
ways supporting a gigabit-capable WAN interface. Options are
1370
-
1492 bytes
. The default is
1492
bytes.
Use Base MAC Address on
this WAN interface
Use the SmartRG Devices Base (Primary) MAC address. When
unchecked, a unique MAC is assigned for each service.
Enable MAC Clone (
Appears when Use Base MAC Address is NOT selected
) Enter the
MAC address to be used as the close address.
8. Click Next. The following page appears where you will select the interface used as a default gateway used for the PPP ser-
vice being created.