User's Manual
Table Of Contents
- Welcome!
- Getting Familiar with your Gateway
- Installing your SR700ac Gateway
- Logging into your Gateway's UI
- Device Info
- Advanced Setup
- LTE WAN Service
- Wireless
- Diagnostics
- Management
- Logging Out
- Appendix: Compliance Statements
- Revision History
SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 38
Field Name Description
not specify a prefix length, the default of
/64
is used.
Specify the Next-Hop IPv6
address
In the
WAN Next Hop IPv6 Address
field, enter the IP address of the next WAN in the group.
This address can be either a local link or a global unicast IPv6 address.
7. Click Next. The following page appears.
8. Modify the settings if desired. All settings are optional.
Network Address Translation (NAT) allows you to share one Wide Area Network (WAN) IP address for multiple computers on
your Local Area Network (LAN). If you do not want to enable NAT (atypical) and wish the user of this gateway to access the
Internet normally, you need to add a route on the uplink equipment. Failure to do so will cause access to the Internet to fail.
The fields on this page are explained in the following table.