User's Manual
Table Of Contents
- Welcome!
- Getting Familiar with your Gateway
- Installing your SR700ac Gateway
- Logging into your Gateway's UI
- Device Info
- Advanced Setup
- LTE WAN Service
- Wireless
- Diagnostics
- Management
- Logging Out
- Appendix: Compliance Statements
- Revision History
SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 47
Field Name Description
options. Zero compression is not supported. Make sure to enter zeros between the colons, that is, do not
use shorthand notation (::2). Options are:
l Start interface ID: Enter the beginning IPv6 available addresses for DHCP to assign to LAN devices.
l End interface ID: Enter the ending IPv6 available addresses for DHCP to assign to LAN devices.
l Leased Time (hour): Amount of time before a new IPv6 lease is requested by the LAN client.
Enable RADVD (
Optional
) This option is enabled by default. It enables Router Advertisement Daemon (RADVD) service that
sends router advertisements to LAN clients. Clear the check box to disable RADVD. Options are:
l Randomly Generate: This option is selected by default. The prefix is generated automatically.
l Enable ULA Prefix Advertisement: Check this option to enable unique local address (ULA) advert-
isement on the LAN. When you select this option, the Randomly Generate option is selected and the
gateway can generate a random IPv6 prefix.
l Statically Configure: Select this option to configure the IPv6 prefix, and enter values in the Prefix,
Preferred Life Time, and Valid Life Time fields (in hours). The default value for the Time fields is -1
(no limit).
Enable MLD Snooping (
Optional
) This option is enabled by default. It enables Multicast Listener Discovery (MLD) snooping to man-
age IPV6 multicast traffic. Options are:
l Standard Mode: Multicast traffic will flood to all bridge ports when no client subscribes to a mul-
ticast group even if IGMP snooping is enabled.
l Blocking Mode: The multicast data traffic will be blocked and not flood to all bridge ports when
there are no client subscriptions to any multicast group. This is the default.
Enable MLD LAN to
LAN Multicast
(
Optional
) This option is enabled by default. It enables LAN-to-LAN Multicast until the first WAN service is
connected. Options are
Disable
and
Enable
. The default is
Disable
.
Ethernet Config
On this page, you can set the speed and duplex mode for the Ethernet ports and the WAN port, if configured,