User's Manual

Table Of Contents

Security

In this section, you can configure filtering for IP and MAC.

IP Filtering - Outgoing

On this page, you can add an outgoing filter when refusal of data from the LAN to the WAN is desired.

1. In the left navigation bar, click Advanced Setup > Security and then click Add. The following page appears.

2. Fill in the fields, using the information in the table below.

3. Click Apply/Save to commit the completed entry.

The fields on this page are explained in the following table.

Field Name Description

Filter Name Enter a descriptive name for this filter. This is a free-form text field.

IP Version For the filter to be configured and effective for IPV6 , the gateway must be installed on a net-

work that is either a pure IPV6 network (with that protocol enabled) or is both IPV4 and IPV6

dual protocol enabled/configured. Options are

IPv4

and

IPv6

. The default is

IPv4

If you select IPV6, both the Source and Destination IP address must be specified in IPV6 format.

The following is an IPV6-compliant, hexadecimal address:

2001:0DB8:AC10:FE01:0000:0000:0000:0001.

Protocol Select the protocol profile for the filter you are defining. TCP/UDP is most commonly used.

The options are

TCP/UDP

TCP

UDP

, and

ICMP