User's Manual

Table Of Contents
SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 54
Field Name Description
Source IP
address [/prefix
length]
Enter the source IP address of a LAN side host for which you wish to filter/block outgoing traffic
for the specified protocol(s).
Note: The address specified here can be a particular address or a block of IP addresses on a
given network subnet. This is done by appending the associated routing "/prefix" length
decimal value (preceded with the slash) to the addresses. A valid decimal routing prefix is
required for defining the subnet mask per CIDR notation.
Source Port (port
or port:port)
Set the outgoing host port (or range of ports) for the above host (or range of hosts defined by
optional routing or "/prefix" subnet mask) to define the ports profile for which egress traffic
will be filtered from reaching the specified destination(s).
Destination IP
address
Enter the destination IP address of a LAN side host for which you wish to filter/block outgoing
traffic for the specified protocol(s).
Note: The address specified here can be a particular address or a block of IP address on a given
network subnet. This is done through appending the address with the routing " /prefix " length
decimal value (preceded with the slash) associated. A valid decimal routing prefix is required
for defining the subnet mask per CIDR notation.
estination Port
(port or port:-
port)
Set the destination host port (or range of ports) for the above host (or range of hosts) to define
the destination port profile for which the filtered host egress traffic will be filtered from reach-
ing the otherwise intended destination(s), e.g., to block the traffic to those ports on, say, a
computer external to the local network.
IP Filtering - Incoming
On this page, you can add an incoming filter when refusal of data from the WAN to the LAN is desired.
Note: This option is not available in the SR515ac model.
1. In the left navigation bar, click Advanced Setup > Security > IP Filtering > Incoming and then click Add. The following page
appears.