User's Manual

SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 60
QoS Config
On this page, you can enable QoS and set the DSCP Mark classification.
The maximum number of queues that can be configured vary by mode, as shown below.
Mode Maximum # of queues
ATM 16
Ethernet 4 per interface
PTM 8
Note: Wireless queues (e.g., the WMM Voice Priority queue) are shown only when wireless is enabled. If the WMM Advertise func-
tion on the Wireless Basic Setup page is disabled, assigning classifications to wireless traffic has no effect.
1. In the left navigation bar, click Advanced Setup > Quality Of Service > QoS Config. The following page appears. QoS is
enabled by default.
2. To disable this feature, click the Enable QoS checkbox.
3. (Optional) In the Select Default DSCP Mark field, select the default Differentiated Services Code Point (DSCP) Mark clas-
sification value to be used. For a list of supported values, see "Supported DSCP Values". The default is No Change(-1).
Warning: If this option was already enabled and you clear the checkbox, QoS will be disabled for ALL interfaces.
4. Click Apply/Save to save your settings.