User's Manual
Table Of Contents
- Welcome!
- Getting Familiar with your Gateway
- Installing your SR700ac Gateway
- Logging into your Gateway's UI
- Device Info
- Advanced Setup
- LTE WAN Service
- Wireless
- Diagnostics
- Management
- Logging Out
- Appendix: Compliance Statements
- Revision History
SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 61
Supported DSCP Values
The DSCP marking QoS Queue Management Configuration marking on ingress packets is based on the selection you make in the Select
Default DSCP Mark field. The selected default marking is applied automatically to all incoming packets without reference to a par-
ticular classification.
Note: A default DSCP mark value of Default(000000) will mark all egress packets that do NOT match any classification.
The following values are supported. For more information about commonly used DSCP values, refer to RFC 2475.
No Change(-1) CS1(001000) AF32(011100) CS4(100000)
Auto Marking(-2) AF23(010110) AF31(011010) EF(101110)
Default(000000) AF22(010100) CS3(011000) CS5(101000)
AF13(001110) AF21(010010) AF43(100110) CS6(110000)
AF12(001100) CS2(010000) AF42(100100) CS7(111000)
AF11(001010) AF33(011110) AF41(100010)
QoS Queue Config
On this page you can configure a queue and add it to a selected Layer2 interface.
1. In the left navigation bar, click Advanced Setup > Quality Of Service > QoS Queue Config and then click Add. The following
page appears.
2. In the Name field, enter a brief descriptive name for this queue.