User's Manual

SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 65
Field Name Description
Rule Status Select whether this rule is active or inactive. Options are:
Enable
and
Dis-
able
. The default is
Enable
.
Specify Classification Criteria
section
Ingress Interface Select an interface. Options are
LAN
,
WAN
and any interface already con-
figured for your gateway.
Ether Type Select the Ethernet interface type for this classification. Options include:
IP
,
ARP
,
IPV6
,
8855
,
8856
,and
8021Q
.
Source MAC Address
Source MAC Mask
Enter the source MAC address and mask for this classification.
Destination MAC Address
Destination MAC Mask
Enter the destination MAC address and mask for this classification.
Source IP Address/Mask
Vendor Class ID
User Class ID
(
Appear when you select IP or IPv6 in the Ether Type field
) Select an
option and enter the appropriate value, i.e, the source IP address and
Source IP mask, vendor class ID, or user class ID.
Destination IP
Address/Mask
Enter the destination IP Address and Mask for this classification.
Differentiated Service
Code Point (DSCP) Check
Select the DSCP code that must be present in the queue identifiers.
Protocol Enter the protocol specified for this classification. Options are
TCP
,
UDP
,
ICMP
, and
IGMP
.
UDP/TCP Source Port (
Appears when TCP or UDP is selected in the Protocol field
) Enter the
source port for this classification. You can enter a single port or a range of
ports (port:port).
UDP/TCP Destination Port (
Appears when TCP or UDP is selected in the Protocol field
) Enter the des-
tination port for this classification. You can enter a single port or a range of
ports (port:port).
802.1p Priority Check (Appears when
8021Q
is selected in the
Ether Type
field) Select priority
level. Options are 1 - 7.
Specify Classification Results
section
Specify Egress Interface Select the egress interface for this rule. Options are the interfaces already
configured.
Specify Egress Queue Select the egress queue for this rule. Options are the queues already con-
figured.
Mark Differentiated Ser-
vice Code Point
Select the desired DSCP code.
Mark 802.1P priority This value is inserted into the Ethernet frame and used to differentiate
traffic. Lower values assign higher priorities. Options are:
1
-
7
.
Set Rate Limit (Kbps) Enter the data traffic rate limit applied for this classification.