User's Manual

Table Of Contents
SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2017 92
Field Name Description
Model Model of the LTE Module.
Firmware Version Firmware version of the LTE Module
IMEI International Mobile Equipment Identity is a unique 15-digit number used to identify valid equip-
ment on a network provider.
IMSI International Mobile Subscriber Identity is a unique number stored on the SIM Card used to identify
the subscriber of the network provider.
LTE Information
section
Network Connected Status State of the LTE connection. Options are
4G Connected
,
3G Connected
,
Disconnected
,
Not
Attached
, and
SIM Card not detected
.
Signal Quality Quality of the LTE signal. Options are
Excellent
,
Average
,
Poor
, and
No Signal
.
RSSI Received Signal Strength Indicator. The measured dBm level of the received radio signal with the
network provider. If no signal is found, “No Signal” appears in this field.
IPv4 Address IPv4 Address for the LTE connection.
Network Settings
On this page, you can configure the Network Settings of the LTE connection between your provider and your gateway.
1. Insert the SIM card received from your network provider into the SIM card slot on the back of the SR700ac with the gold con-
tacts facing up.
Note: The SIM card slot is located beneath the black WAN Ethernet port on the back of the gateway.
2. In the left navigation bar, click LTE WAN Service > Network Settings. The following page appears.
3. Modify the settings as needed, using the information provided in the table below.
4. Click Save to commit your changes.
Note: The settings take up to 90 seconds to save.
The fields on this page are explained in the following table.