Instruction Manual
11.1 Wireless Remote Sensor Pairing
Step 1:
— Connect the weather station with power supply.
— Insert 2 x AA batteries to each wireless remote sensor.
Step 2:
— Select channel through the "1 2 3" knobs for the wireless
remote sensor. The indicator light up once to indicate the detected
temperature and humidity were sent out by wireless remote sensor.
— Select a channel for the weather station that corresponds to
the wireless remote sensor. Press "
" button to select CH1,
CH2, CH3 or CH1 to CH3 (every 5 seconds automatically switch a
channel).
— The weather station can connect up to 3 wireless remote
sensors at the same time. If multiple wireless remote sensors were
used simultaneously, they can not be set as the same channel (a
total of 1, 2, 3 channel can be set).
—When the weather station successfully receives signals from the
wireless remote sensor, the temperature and humidity detected by the
wireless remote sensor are displayed on " OUTDOOR REMOTE "
column of the weather station.
11.2 Manually Start the Wireless Remote Sensor Signal Reception
If "--" displayed on the weather station, it indicates the weather
station failed to receive signals from wireless remote sensor, please
take following operations.
— Press and hold "
" button for 3 seconds to receive signals
manually. The outdoor temperature will show an animation of the
RF antenna symbol, the weather station will try to receive signals
from the wireless remote sensor again.
— Press " TX " button on wireless remote sensor to send out
signals manually.
11.3 °C/°F Temperature Display
The temperature displayed on wireless remote sensor either in °C
or °F. Briey press " °C/°F " button allows you to switch between
the individual modes.
11.4 Placement of wireless sensors
●
The wireless remote sensor is not waterproof.
●
The sensor can be placed anywhere (indoor or outdoor) you
want to measure the temperature remotely.
●
If you want to measure the outdoor temperature, please place
the sensor outside away from direct sunlight and rain such as
under eaves or on a porch.
Please take note of the following:
●
When the outdoor temperature is between –1°C ~ 2.9°C (30.2°F
~ 37.3°F), the frost alarm function will be activated and a ashing "
" symbol will be displayed on the weather station.
11. Wireless Remote Sensor Pairing &
Manual Setting
15 16