Instruction Manual

Part C –Wireless Remote Sensor
C1: LCD display – Temperature
C2: LCD display – Humidity
C3: Transmit signal LED
C4: "°C/°F" button
C5: "TX" button
C6: "CHANNEL 1 or 2 or 3" switch
C7: Battery compartment
6. Getting Start
●
Plug in the power adapter to the clock.
●
When the clock is successfully connected to the power supply, all
the symbols on the LCD display will light up. You will hear a "di di
di" sound. The projection clock starts to detect indoor temperature
and humidity.
●
At the same time, unscrew the battery cover according to the
OPEN direction note, take out the battery insulation sheet. Screw
the battery cover back.This battery is used for keeping manual
setting only, it can’t be used as a normal working power supply.
●
Open the wireless remote sensor battery compartment cover, set
channel for the wireless remote sensor through the C7 position and
Insert 2 x AA batteries to each wireless remote sensor. Ensure that
the battery polarities [ "+" and "–"] are correct. Close the battery
compartment.
●
The projection clock starts to make a connection with the
wireless remote, displayed by a flashing reception RF antenna
symbol in the channel display area on the LCD screen. This
procedure will take about 3 minutes maximum.
●
After the clock receiver made a connection to the outdoor
wireless remote sensor, it will enter the normal mode.
87