Instruction Manual

13
Please take note of the following:
●
The alarm will keep ringing for 2 minutes if you do not deactivate
it by pressing any button. In this case the alarm will automatically
repeat the next day.
●
The ring of the alarm changes 4 times in total during the past 2
minutes.
●
The Snooze time setting range: 5 ~ 60MIN, OFF, when set to
OFF, means no Snooze function.
8.3 Turn o󰀨 the Alarm Tone
●
Alarm tone will automatically turn o󰀨 after 2 minutes or you can
press any button except " SNOOZE/LIGHT " to turn o󰀨 the alarm
tone. The alarm will repeat automatically at the same time of the
next day.
8.4 Snooze Function
●
Under the Snooze function activated status. You can activate the
Snooze function by pressing " SNOOZE/LIGHT " when the alarm is
ringing. The symbol of "
" or " " starts to ash, then alarm will
ring again after the Snooze time.
●
Under the Snooze function activated status. Press any button
except " SNOOZE/LIGHT " button or press and hold " SNOOZE/
LIGHT " button for 2 seconds to exit the snooze mode.
●
If one alarm is in Snooze function, the other alarm rings, it will
automatically stops the Snooze function of the rst alarm.
10. Backlit Adjustment
●
When the clock is powered by DC power adapter, the battery will
automatically disconnect with the power supply, the backlit will be
bright all the time.
●
Press " SET " button to adjust 4 backlit brightness, light - medium
- low - out.
●
Press " SNOOZE/LIGHT " button to light up backlit for 15
seconds when the backlit in out status.
14
9. Projection Setting
●
When the projection shift switch is pushed in the " ON " position,
the projection display will light up.
●
When the projection shift switch is pushed in the " OFF "
position, the projection display will be closed. Under this states,
press " SNOOZE/LIGHT " button to light up the projection for 15
seconds.
●
Press and hold " " button for about 3 seconds to switch the
brightness of projection from high to low, or low to high.
●
Shot press " " button to adjust the projection angle by 180°.
●
The suggested distance of projection is 3.3 ~ 9.8 ft (1 ~ 3 m).
When there is no light at night, the clock can clearly display the
time and temp on the wall or ceiling.
●
The contents of the projection display are time and indoor or
outdoor temperature composition. The projection will circularly
display every 5 seconds for indoor / outdoor temperature.