User's Manual

iSmartEV P01 User Manual

www.newsmartsafe.com

It needs to be performed in the following cases:

1) The main battery is replaced.

2) The battery monitoring sensor is replaced..

11.6 ABS Bleeding

This function allows you to perform various bi-directional tests to check the

operating conditions of Anti-lock Braking System (ABS).

It needs to be performed in the following cases:

1) When the ABS contains air.

2) When the ABS computer, ABS pump, brake master cylinder, brake cylinder,

brake line, or brake fluid is replaced.

11.7 Throttle learning

This function enables you to make initial settings to throttle actuators and returns

the learned values stored on ECU to the default state. Doing so can accurately

control the actions of regulating throttle (or idle engine) to adjust the amount of

air intake.

Cases when throttle learning is required:

1) After the replacement of the ECU, the ECU does not store the

characteristics related to the working of the throttle, so the throttle matching

is required.

2) After the power-off of the ECU, the memory of the ECU memory is lost,

and throttle matching is required.

3) After replacing the throttle assembly, the throttle matching is required.

4) After the replacement or disassembly of the inlet, the coordination of the

ECU and throttle body on the idle speed control will be affected, and the

throttle matching is required.

5) After cleaning the throttle, the characteristics of the idle throttle

potentiometer have not changed, but under the same throttle opening, the

air intake has changed, and the idle control characteristics have changed.

At this time, it is necessary to match the throttle.

11.8 Tire Pressure Monitor System Reset

This function enables you to quickly look up the tire sensor IDs from the vehicle’s

ECU, reset tire pressure and turn off the tire pressure MIL.

It needs to be performed in the following cases:

Tire pressure is too low, tire leaks, tire pressure monitoring device is replaced or