User's Manual

iSmartEV P01 User Manual
www.newsmartsafe.com
43
installed, tire is replaced, tire pressure sensor is damaged, and tire is replaced for
the car with tire pressure monitoring function.
11.9 Diesel Particulate Filter (DPF) regeneration
This function enables you to clear PM (Particulate Matter) from the DPF
filter through continuous combustion oxidation mode (such as high
temperature heating combustion, fuel additive or catalyst reduce PM
ignition combustion) to stabilize the filter performance.
It needs to be performed in the following cases:
1) The exhaust back pressure sensor is replaced.
2) The PM trap is removed or replaced.
3) The fuel additive nozzle is removed or replaced.
4) The catalytic oxidizer is removed or replaced.
5) The DPF regeneration MIL is on and maintenance is performed.
6) The DPF regeneration control module is replaced.
11.10 Gearbox Matching
This function enables you to complete the gearbox self-learning to improve gear
shifting quality.
It needs to be performed in the following cases:
When the gearbox is disassembled or repaired.
11.11 Gear Learning
This function enables you to perform tooth learning for the car, to turn off the MIL.
It needs to be performed in the following cases:
1) After the engine ECU, crankshaft position sensor, or crankshaft flywheel is
replaced.
2) The DTC 'tooth not learned' is present.
11.12 Motor Angle Calibration Diagnosis
When the rotor position detected by the motor angle position sensor is different
from the actual rotor field position, motor angle calibration must be performed.
11.13 Coolant Bleed
Use this function to activate the electronic water pump before venting the cooling
system.
11.14 Engine Power Balance Monitoring Diagnosis