User's Manual

iSmartEV P01 User Manual
www.newsmartsafe.com
44
It is used to monitor crankshaft acceleration in the power stroke of each cylinder,
to determine the relative power provided by each cylinder.
11.15 IMMO Service
This function enables you to perform the anti-theft key matching function, so that
the immobilizer control system on the car identifies and authorizes remote control
keys to normally use the car.
It needs to be performed in the following cases:
When the ignition switch key, ignition switch, combined instrument panel, ECU,
BCM, or remote control battery are replaced.
11.16 High Voltage Battery Diagnostics Diagnosis
It is used for high voltage battery diagnosis and status information detection.
11.17 Gas Particulate Filter Regeneration Diagnosis
After the GPF is used for a long time, fuel consumption is increased and engine
output power is reduced. In this case, the GPF replacement or regeneration must
be performed.
11.18 Transport Mode
In order to reduce power consumption, the following functions may be disabled,
including limiting the vehicle speed, not waking up the door opening network, and
disabling the remote control key, etc. At this time, the transport mode needs to be
deactivated to restore the vehicle to normal.
11.19 Tire Reset
This function is used to set the size parameters of the modified or replaced tire.
11.20 Windows Calibration
This feature is designed to perform door window matching to recover ECU initial
memory, and recover the automatic ascending and descending function of power
window.
11.21 AdBlue Reset
After the diesel exhaust treatment fluid (car urea) is replaced or filled up, urea
reset operation is required.
11.22 NOx Sensor Reset
NOx sensor is a sensor used to detect the content of nitrogen oxides (NOx) in
engine exhaust. If the NOx fault is re-initialized and the NOx catalytic converter is