User's Manual

iSmartEV P01 User Manual
www.newsmartsafe.com
45
replaced, it is necessary to reset the catalytic converter learned value stored in
the engine ECU.
11.23 Injector Coding
This function enables you to write injector actual code or rewrite code in the ECU
to the injector code of the corresponding cylinder, so as to more accurately
control or correct cylinder injection quantity.
It needs to be performed in the following cases:
After the ECU or injector is replaced.
11.24 Airbag Reset
The function can reset airbag data and clear DTCs related to airbag collision;
when the vehicle collides and the airbags are deployed, a corresponding DTC of
the collision data shall be generated and the airbag indicator will be on. The DTC
cannot be cleared. Since the data in airbag ECU are one-off, it’s necessary to
replace the accessories with new ones as required. However, the execution of
this function can recover the data in airbag ECUs and clear the DTC. The airbag
indicator will go out and the airbag ECUs can be used continually.
11.25 Stop/Start Reset
This function is used to open or close the automatic start-stop function via setting
the hidden function in ECU (provided that the vehicle has a hidden function and
supported by hardware).
11.26 Sunroof Initialization
This function enables you to set the sunroof lock off, closed when it rains, sliding
/ tilting sunroof memory function, temperature threshold outside the car etc.
11.27 Suspension Calibration
This function enables you to adjust the height of the body.
It needs to be performed in the following cases:
1) When replacing the body height sensor, or control module in the air
suspension system.
2) When the vehicle height is incorrect.
11.28 Odometer Calibration Diagnosis
Instrument panel mileage calibration is used to copy or rewrite mileages. That is,
use the car diagnostic computer and data line to copy, write or rewrite chip data
on the instrument panel to make the instrument panel display actual mileages.