User's Manual

iSmartEV P01 User Manual
www.newsmartsafe.com
41
11. Special Functions
This module provides the quick entry for commonly used special function
operation, including A/F adjustment, brake pad replacement, maintenance lamp
returns to zero, steering angle learning, battery replacement, ABS exhaust,
throttle learning, tire pressure reset, DPF regeneration, wave case learning, gear
learning, headlamp matching, electronic water pump start, engine power balance,
anti-theft matching, high pressure accumulator health detection, GPF
regeneration and release of transport mode etc. If you need to operate more
special functions, you can enter the diagnostic model software to operate。
Note: The specific special functions provided depend on the vehicle type
.
11.1 A/F Reset
This function is applied to set or learn Air/Fuel ratio parameters.
11.2 Electronic Parking Brake Reset
This function enables you to reset the brake pad after replacing the brake pad.
It needs to be performed in the following cases:
1) The brake pad and brake pad wear sensor are replaced.
2) The brake pad indicator lamp is on.
3) The brake pad sensor circuit is short, which is recovered.
4) The servo motor is replaced.
11.3 Oil Reset Service
If the service lamp is on, run car diagnostics first for troubleshooting. After that,
reset the driving mileage or driving time, so as to turn off the service lamp and
enable a new driving cycle.
11.4 Steering Angle Calibration
This function enables you to reset the steering angle, after replacing the steering
angle position sensor, replacing steering mechanical parts (such as steering
gearbox, steering column, end tie rod, steering knuckle), performing four-wheel
alignment, or recovering car body.
11.5 Battery Maintenance System Reset
This function enables you to perform a resetting operation on the monitoring unit
of vehicle battery, in which the original low battery fault information will be
cleared and battery matching will be done.