User's Manual

iSmartEV P03 User Manual
www.newsmartsafe.com
87
cycle.
11.4 Steering Angle Calibration
This function enables you to reset the steering angle, after
replacing the steering angle position sensor, replacing steering
mechanical parts (such as steering gearbox, steering column,
end tie rod, steering knuckle), performing four-wheel alignment,
or recovering car body.
11.5 Battery Maintenance System Reset
This function enables you to perform a resetting operation on the
monitoring unit of vehicle battery, in which the original low battery
fault information will be cleared and battery matching will be done.
It needs to be performed in the following cases:
1) The main battery is replaced.
2) The battery monitoring sensor is replaced.
11.6 ABS Bleeding
This function allows you to perform various bi-directional tests to
check the operating conditions of Anti-lock Braking System (ABS).
It needs to be performed in the following cases:
1) When the ABS contains air.
2) When the ABS computer, ABS pump, brake master cylinder,
brake cylinder, brake line, or brake fluid is replaced.
11.7 Throttle Learning
This function enables you to make initial settings to throttle
actuators and returns the learned values stored on ECU to the
default state. Doing so can accurately control the actions of
regulating throttle (or idle engine) to adjust the amount of air
intake.