User's Manual

iSmartEV P03 User Manual
www.newsmartsafe.com
89
(such as high temperature heating combustion, fuel additive or
catalyst reduce PM ignition combustion) to stabilize the filter
performance.
It needs to be performed in the following cases:
1) The exhaust back pressure sensor is replaced.
2) The PM trap is removed or replaced.
3) The fuel additive nozzle is removed or replaced.
4) The catalytic oxidizer is removed or replaced.
5) The DPF regeneration MIL is on and maintenance is
performed.
6) The DPF regeneration control module is replaced.
11.10 Gearbox Matching
This function enables you to complete the gearbox self-learning
to improve gear shifting quality.
It needs to be performed in the following cases:
When the gearbox is disassembled or repaired.
11.11 Gear Learning
This function enables you to perform tooth learning for the car, to
turn off the MIL.
It needs to be performed in the following cases:
1) After the engine ECU, crankshaft position sensor, or crankshaft
flywheel is replaced.
2) The DTC 'tooth not learned' is present.
11.12 Motor Angle Calibration
When the rotor position detected by the motor angle position
sensor is different from the actual rotor field position, motor angle
calibration must be performed.