User's Manual

iSmartEV P03 User Manual
www.newsmartsafe.com
90
11.13 Coolant Bleed
Use this function to activate the electronic water pump before
venting the cooling system.
11.14 Engine Power Balance Monitoring
It is used to monitor crankshaft acceleration in the power stroke of
each cylinder, to determine the relative power provided by each
cylinder.
11.15 IMMO Prog
This function supports the reading and writing of car key chip,
EEPROM chip, MCU chip, EEPROM and flash of engine ECU
and transmission ECU.
11.16 IMMO Service
This function enables you to perform the anti-theft key matching
function, so that the immobilizer control system on the car
identifies and authorizes remote control keys to normally use the
car.
It needs to be performed in the following cases:
When the ignition switch key, ignition switch, combined
instrument panel, ECU, BCM, or remote control battery are
replaced.
11.17 High Voltage Battery Diagnosis
It is used for high voltage battery diagnosis and status information
detection.
11.18 Gas Particulate Filter Regeneration
After the GPF is used for a long time, fuel consumption is