User's Manual
iSmartEV P03 User Manual
www.newsmartsafe.com
73
to be tested and the conductive part of the test clip.
• Select a suitable range for measurement according to the
parameters of the equipment to be tested.
• Release the charge in the circuit to be tested after completing
the measurement. Tap Close the measurement button on the
screen or the TEST button in the function button area, and then
remove the test clip after the screen prompts "Measurement
closed".
9.3 How to Operate
The P03 main unit is equipped with the insulation test function
button area. In addition to operating through the screen touch
button, you can also set and control the insulation test function
module through the buttons in the function button area.
Button Position
Button
Identification
Button Description
COMP
Click to enter the "Comparative
measurement" mode.
TIME
Click to switch between "Timing
measurement" and "Continuous
measurement".
MODE
Click to switch between "Resistance
measurement", "DC Voltage
measurement" and "AC Voltage
measurement".
TEST
Control the start and end of the
measurement when "Resistance
measurement" is performed.
Up And Down
Direction
Buttons
Adjust the value of "Output voltage".