User's Manual

iSmartEV P03 User Manual
www.newsmartsafe.com
75
measurement measurement".
2
Voltage
measurement
Click to switch to "Voltage measurement",
and there are two options of "DC voltage"
and "AC voltage".
3
Comparison
measurement
Click to switch to "Comparison
measurement".
4
Timing
Measurement
Click to switch to "Timing measurement".
5
Continuous
Measurement
Click to switch to "Continuous
measurement".
6
Measurement
Result Display Area
7
Begin the
Measurement/Close
the Measurement
Click "Begin the measurement" and click
"Close the measurement" after the
measurement is completed.
8
Output Voltage
Regulation
Click "-" to reduce the voltage value, and
click "+" to increase the voltage value.
9
Comparison
Resistance
Adjustment
Click "-" to reduce the resistance value, and
click "+" to increase the resistance value.
2. Tap Resistance Measurement or use the MODE button to
switch to "Resistance measurement" mode.
3. Insert one end of the red insulation test clip into the "LINE" port
and connect the other end to the high-voltage conductor of the
equipment to be detected. Insert one end of the green insulation
test clip into the "EARTH" port, and connect the other end to the
equipment housing or ground. Insert one end of the black
insulation test clip into the "GUARD" port and connect the other
end to the high-voltage grommet of the equipment to be detected.
Notes: It is forbidden to short circuit the LINE end and the
GUARD end to avoid overload.