User's Manual

iSmartEV P03 User Manual
www.newsmartsafe.com
76
4. There are three measurement methods for Resistance
measurement: Comparison measurement, Timing measurement
and Continuous measurement.
Comparison Measurement
1) Tap Comparison Measurement or click the COMP button in
the function button area.
2) Click -/+ or the left and right direction buttons in the function
button area to set the comparison resistance value, click -/+ or
the up and down direction buttons in the function button area to
set the output voltage value, and then tap Begin the
Measurement or long press the TEST button to start
measurement.
3) After the measurement is completed, the screen will display
the measured resistance value. If the measured resistance value
is not less than the set comparison resistance value, the upper
right corner of the screen will display "GOOD". If the measured
resistance value is less than the set comparison resistance value,
the upper right corner of the screen will display "NG".
4) Tap Close the Measurement or click TEST again to end