User's Manual

iSmartEV P03 User Manual
www.newsmartsafe.com
40
out of the screen.
• Min/Max Limit: Click to set the
maximum/minimum value. Once the running value
exceeds the set value, the system will issue a
warning.
Report
Click to save the current data stream value as a
report. The saved test report is stored in Other ->
Reports -> Diagnostic.
Record
Click to start recording test data. The recorded test
data can provide an important reference for
technicians to troubleshoot vehicle problems. To
stop reading, click the button in front of the
progress bar.
Note: The saved file is named after vehicle
type +VCI device serial number + system time
when recording starts. To distinguish file names,
please set the correct system time.
E. Actuation Test
This function is mainly used to test whether the executive
component in the electronic control system can work normally.
6.2.3 Choose to Scan
This function is used to select the vehicle electronic control
system required by the user for scanning. In the test option
selection interface, check the check box in front of the system to
be scanned, and then tap Choose to Scan to start scanning the
selected system.