Quick Start Guide

SmartSense B Sensor: Regulatory Information

RF Exposure Statement

In order to comply with RF exposure limits established in the ANSI C95.1 standards, the distance between the

antenna or antennas and the user should not be less than 20 cm.

FCC Certications and Regulatory Information (USA only)

FCC Part 15 Class B

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Radio Frequency Interface (RFI) (FCC 15.105)

This device has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15

Subpart B, of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential environment. This equipment generates, uses, and can radiate radio frequency energy,

and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try and correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Modications (FCC 15.21)

CAUTION: Changes or modications to this equipment not expressly approved by Digi may void the user’s authority

to operate this equipment.

Industry Canada (IC) Certications

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two

conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de

licence. L’exploitation est autorisée aux deux conditions suivantes :

(1) l’appareil ne doit pas produire de brouillage, et

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible

d’en compromettre le fonctionnement.

For more information about SmartSense

visit www.smartsense.co or call 1-866-806-2653

A1/819