Installation Instructions

LP SmartSide Trim & Fascia
190, 440, 540 & 2000 Series Strand & Fiber Substrate
Smooth Finish or Cedar Texture
Primed Trim & Fascia
Application Instructions
ON SITE STORAGE
• Store o the ground well supported, on a at well-drained
surface. Store products under a roof or separate waterproof
covering. (See diagram 1a)
• Additional support may be required to achieve a safe clearance
from the ground.
• When the waterproof covering is removed cut all unit banding.
• Keep trim and fascia clean and dry. Inspect prior to installation.
PREPARATION
General Information
1a
A - Corners (Page 6) E - Board and Batten (Page 10)
B - Windows, Doors, Openings (Page 7) F - Mounting Blocks (Page 11)
C - Gable Ends and Barge Rafters (Page 9) G - Exterior Columns (Page 11)
D - Fascia and Rake (Page 9)
A
B
G
F
E
D
C
• Louisiana-Pacic’s application instructions describe the minimum requirements needed to assure LP SmartSide limited
warranty coverage.
• Trim and fascia installations not in compliance with LP application instructions are prone to reduced service life and products
subject to such installation are excluded from coverage under the LP SmartSide limited warranty.
• All exposed wood substrate must be sealed in a manner that prevents moisture intrusion and water build up.
• All wood substrate that is exposed to the weather must be sealed in a manner that prevents moisture intrusion and water
build up.
- Seal ALL exposed cuts of siding and trim. Field spray applied coatings on cuts are not recommended.
- Sealing can be accomplished by applying a coating or sealant according to the manufacturer’s requirements.
- Butt joints that are covered with joint molding, sealant or factory prenished end, are considered sealed from
the weather.
• LP SmartSide trim and fascia can be applied directly over materials such as siding, or fastened directly to structural members
up to 24 inches o.c. (610 mm).
• Trim and fascia are not designed for siding; or structural applications and should not be used as a structural member in
construction such as a trellis, railing, fencing, decking, decking trim or sills.
• When integrating ashing with a water-resistive barrier (WRB), be sure to follow the WRB installation instructions.
• Install siding products only on walls whose framing members have been kiln dried or air-seasoned to a moisture content of
19% or lower.
• Do not install siding on walls with crooked framing materials.
• Do not install siding over rain-soaked or buckled sheathing.
1