DIC-222 Intercom Series Instruction Manual
WARNING PRODUCT OVERVIEW 1. Please read these instructions carefully before installing and using the product. 2. Do not cut the power supply cable to extend it; the device (transformer) will not work with a longer cable. Do not plug in the device until all the wiring has been finished. INDOOR MONITOR INSTALLATION SAFETY 1. Keep children and bystanders away while installing the products. Distractions can cause you to lose control. 2. Do not overreach when installing this product.
INSTALLATION INSTALLATION When installing the outdoor unit, make sure that the location you wish to install it is dry. It is important that the camera or the electronics do not get wet. 1. Mark the installation location 2. Drill a hole in the wall, insert wall plugs and screw unit onto wall. 3. Open the panel by the arrow direction 4. Pull the wires from the hole 1. Drill holes in the wall, insert the wall plugs in the holes. Place the bracket and tighten the screws. 2.
INSTALLATION INSTALLATION 5. 1 7. 8. The green terminals into the 1.2 The orange terminal into the DC 15V IN 9. Plug in the power and check the wiring is correct 10. Cover the panel 11. Indoor-monitor to insert the smart bracket. Take out the green terminal from accessories bag, connect the wires to the outdoor unit 1 2 DC 15V IN 2 2 1 ON 6.
INSTALLATION INSTALLATION HOW TO CONNECT AN EXTRA MONITOR 1. Take out the blue terminal from accessories bag, connect the wires to extension unit ON 2. The blue terminal into the 3.4 Power Lock 1 1 2 2 1 Lock 2 1 Power A B C D 3 4 2 1 2 Indoor Monitor Extension Additional Indoor Monitors 3 Distance between units Wiring 4 1 - 50m 1 - 100m Extra indoor-monitors are optional, depending on how many indoor units you intend to use.
USE MAIN MENU Intercom function: When in standby, when a visitor presses the call button on the outdoor unit, the indoor-monitor will chime and you will see a live view of the visitor on the screen. Press the intercom button to speak to the visitor. • Press the menu button to enter the main menu. • Navigate the menu by using the left and right button. Confirm your selection with the OK button. Go back a step with the Menu button.
TECHNICAL SPECIFICATION INDOOR MONITOR Supply Voltage 15V 1A Screen size 7” (diagonal) inch Color configuration R.G.B.delta Video System PAL/NTSC Effective Pixels 800x3(RGB)x480 Consumption current 500 ± 200mA Operation temperature -10˚C - +50˚C Operation Humidity 85%(Max) Picture Type JPEG Video Type AVI OUTDOOR UNIT Imaging sensor type 1/4” CMOS View angle about 100˚ Effective pixels 1288 (H) x 728 (V) Minimum illumination 1Lux/F1.2 Night vision distance about 0.
