Operation Manual

3
INTRODUCTION AND GENERAL POINTS
CONGRATULATIONS, you have just made a great step to protect yourself, your home and its content
and against assault and theft. Of course an alarm system does not constitute an absolute guarantee
against these wrongdoings, but it is sufficiently deterrent.
PRE-PROGRAMMING
The accessories of the HA700+ were preprogrammed in the factory to a standard configuration that
reduces the installation time to the bare minimum.
Indeed, you only have to:
- Install the batteries in the detectors and the remote control
- Attach all the items to the wall
- Install the batteries, attach the station and connect it to your telephone socket (see page 9).
- Program your message and the telephone call numbers (see page 15)
SYSTEM OPERATION WITH THE PREPROGRAMMED CONFIGURATION
Detector configuration:
- magnetic detector SA68M : programmed in Area 1
- movement detector SA68M : programmed in Area 2
Station in total arming mode
This mode is used only when none is in your home.
In this arming mode, all detectors will trigger the system.
Station in partial arming mode
This mode is used when you are at home.
In this arming mode, only the magnetic detector will trigger the system whereas the movement detector
will be inoperative.
IMPORTANT
If the defined parameters do not match your needs, or if you have to install additional accessories, please
go to section ACCESSORY LEARNING in order to learn or modify the relevant detector(s).