Operation Manual

3. Enter PIN + 15 + PARM to start the binding process. The DISARM LED will start
to blink for 30 seconds with a beep tone.
4. Within 30 seconds, set the device to enter binding mode using its learn-key/
tamper button. Refer to the device’s user manual for details.
For RFID tags, simply swipe it in front of the alarm panel in the area above the
siren.
5. If a device is successfully added, the DISARM LED will turn on for 1 second along
with a long beep sound.
6. If the binding process fails, it will timeout after 30 seconds and 3 short beeps will
be heard.
7. To exit the binding process, press the DISARM Key
11-3 Deleting a sensor or device
Follow the steps in Appendix A to remove a sensor or other devices from the alarm
panel’s binding memory. For sensors/keyfob/RFID tags numbered 1-9, you can
select directly from the keypad.
Note: The alarm panel must be in Disarm mode.
12. Hot Key Functions
Below table is summary of hot-key press on the alarm panel’s keypad.
Function Operation Explanation
Speed Dial TEL_1 Hold 1 Speed dial phone number set 1
Speed Dial TEL_2 Hold 2 Speed dial phone number set 2
Speed Dial TEL_3 Hold 3 Speed dial phone number set 3
Speed Dial TEL_4 Hold 4 Speed dial phone number set 4
Speed Dial TEL_5 Hold 5 Speed dial phone number set 5
PANIC Hold 9 Generate a Call for Help Alarm
Play Alarm Message
Hold Record
Test playback of the user’s
recorded alarm message
All Area Alarm Mode
(Single Key)
Hold Arm Key
May only enter this mode under
Disarm Mode
Partial Area Alarm
Mode (Single Key)
Hold Partial Arm Key
May only enter this mode under
Disarm Mode