Owners Manual Hub/Switch 16 10BASE-T, 100BASE-TX

Access Control List Commands
4-97
4
Command Usage
• You must configure an ACL mask before you can map CoS values to the rule.
• A packet matching a rule within the specified ACL is mapped to one of the
output queues as shown below.
Example
Related Commands
queue cos-map (4-166)
show map access-list mac (4-97)
show map access-list mac
This command shows the CoS value mapped to a MAC ACL for the current
interface. (The CoS value determines the output queue for packets matching an
ACL rule.)
Syntax
show map access-list mac [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
Command Mode
Privileged Exec
Example
Related Commands
map access-list mac (4-96)
Table 4-36. Egress Queue Priority Mapping
Queue
0123
Priority
1,2 0,3 4,5 6,7
Console(config)#int eth 1/5
Console(config-if)#map access-list mac M5 cos 0
Console(config-if)#
Console#show map access-list mac
Access-list to COS of Eth 1/5
Access-list M5 cos 0
Console#