Reduced Wiring System Instruction Manual

2726
Dimensions ( unit : mm )
When only input blocks for M8 connector are connected
44.2
39.7
L3
(L4)
5
L1
L2 ( Rail mounting pitch: 12.5 )
DIN Rail
35
49
32.2
(7.5)
When only input blocks of 8-point-integrated type are connected
L1 [mm] : Rail length
L2 [mm] : Mounting pitch
L3 [mm] :
Manifold length
L4 [mm]
98 110.5 123 135.5 148 160.5 173 185.5
87.5 100 112.5 125 137.5 150 162.5 175
74 86 98 110 122 134 146 158
12 12 12.5 12.5 13 13 13.5 13.5
Stations 12345678
L1 [mm] : Rail length
L2 [mm] : Mounting pitch
L3 [mm] : Manifold length
L4 [mm]
135.5 185.5
125 175
110 158
12.5 13.5
Stations 1 2
Input Unit Manifold Part Names
The Input unit manifold consists of Input unit, input block (s), end block and DIN rail.
The input block up to 8 can be connected ( 16 points ).
Any combination of input blocks ( for M8 connector, M12 connector and 8-point-
integrated type ) is acceptable.
Input unit1
Note1 : For wiring method, refer to subsection "Wiring" ( page 30 ) of section "Input Unit
Manifold" in this manual.
Note2 : For display, refer to "Display" ( page 31 ) in section "Input Unit Manifold" in this manual.
Unit to communicate with GW unit or SI unit.
Communication
connector
2
To be connected with branch cables from GW unit or
SI unit ( branch cable with M12 connector ).
( Note1 )
Power LED3 Indicates the power supply status. ( Note2 )
Input block4 Unit for sensor signal input.
Sensor connector5 Connects with sensor.
( Note1 )
Indicator LED6 Indicates sensor signal status. ( Note2 )
Marker7 To be used for writing input No. etc.
End block8 Composes the end of Input unit manifold.
DIN rail9 To be mounted with Input unit manifold.
Part name
No. Application
Figure shows the configuration when only input blocks for M8 connector are connected.
Do not mix sensor input specifications ( PNP and NPN ).
Note